Machining
CNC milling and turning
3- and 5-axis milling, CNC turning and mill-turning at two sites, from one-offs to series.
Location
Milling and turning take place at two sites: at Wirths & Werres in Wuppertal-Cronenberg, in the Bergisches Land, and at Lungmetall in Kottenheim near Mayen and Koblenz.
Key data
Equipment and capacities
Guide values as stated by the companies. We check feasibility for your specific part.
| Service | Capacity | Company |
|---|---|---|
| 5-axis simultaneous milling | Parts up to 630 × 500 × 508 mm | W&W |
| 3-axis milling | Several machining centres, parts up to 762 × 508 × 508 mm | W&W |
| CNC turning and mill-turning | Up to Ø 350 mm, bar feeder for series | W&W |
| 5-axis milling | Parts up to around Ø 630 mm | Lungmetall |
| Large 3-axis milling | Travel around 1,450 × 660 × 635 mm, table load up to 1,500 kg | Lungmetall |
| CNC turning with sub-spindle | Up to Ø 400 × 800 mm, bar feeder | Lungmetall |
Typical parts
Precision parts and fixtures
Shafts, bushings, flanges
Base plates and large parts
Products
What we make with it
Turned and milled parts
Screw jacksFAQ
Frequently asked questions
How large can milled parts be?
Wirths & Werres mills parts up to 630 × 500 × 508 mm on 5 axes. Lungmetall mills on 3 axes with around 1,450 × 660 × 635 mm travel and up to 1,500 kg table load.
Up to what diameter do you turn?
Wirths & Werres turns up to Ø 350 mm, Lungmetall with sub-spindle up to Ø 400 × 800 mm. Both sites use bar feeders for series.
Do you make one-off parts?
Yes. We make one-offs, prototypes and series, from precision parts and fixtures to shafts, flanges and base plates.
More capabilities
