EDM and grinding
Wire EDM and surface grinding
Wire EDM for fine contours in hardened steel and surface grinding for flat, smooth faces.
Location
EDM and grinding take place at Wirths & Werres in Wuppertal-Cronenberg. The site lies at the heart of the Bergisches Land, close to Solingen, Remscheid and Velbert.
Key data
Equipment and capacities
Guide values as stated by the companies. We check feasibility for your specific part.
Typical parts
Cutting and punching tools
Precision contours in hardened steel
Precision-ground plates
Responsible
Wirths & Werres
Wuppertal-Cronenberg
Products
What we make with it
Turned and milled partsFAQ
Frequently asked questions
How large can the workpiece be for wire EDM?
Up to 350 × 250 × 250 mm.
What is wire EDM suited for?
In wire EDM a thin wire cuts through conductive material by spark discharge. This produces fine, sharp contours even in hardened steel, for example for cutting and punching tools.
What surface finish does surface grinding achieve?
Down to Ra 0.8, for workpieces up to 250 × 350 × 450 mm.
More capabilities
